Avery Dennison Monarch 9855 Operator Handbook - Manual (Page 23)

Loading Supplies 2-7
Loading Labels for the Optional Pee l Mode
Peel mode is an option that must be purchased separately. In peel mode,
the printer separates the backing paper from the label. The next label is not
printed until the completed one is removed from the printer. Make sure the
printer is configured for on-demand mode and the correct supply type.
The minimum feed length is 1.5 inches for peel mode. W e recommend using
0.5-inch gap supplies in peel mode when backfeed is disabled. Hold the
leading edge of peeled labels when printing on stock longer than six inches.
You must use non-perforated supplies for peel mode. Follow the steps for
loading supplies from the previous section. Then, follow these steps after
you close the printhead.
1. Remove the labels from the first 10 inches of the backing paper.
2. Press down on the exit cover tabs to open the exit cover on the front of
the printer.
E xi t Cover