ETA Duplica Vital - Manual (Page 57)

– when the program set is completed (10 beeps),
– when the one-hour keeping warm set is completed (1 beep),
– when the safety function activates (continuous beeping).
Safety function
- When a program is selected, all buttons are disabled except for PAUZA (PAUSE),
CYKLUS (CYCLE), SVĚTLO (LIGHT), and START/STOP.
- If you want to use the bread baker immediately after previous baking and if the appliance
baking space temperature is too high ( over 40 °C), pressing the START/STOP button will
show
H HH
on the display and continuous beeping will be heard. The appliance may not
be operated. Therefore, open the lid or remove the baking pan and wait for cooling the
appliance down.
- If
E EO
or
E E1
appears on the display following the START/STOP button is pressed,
bring the appliance to a service centre.
- In case of power failure during operation, the appliance remembers the program setup for
about ten minutes. In case of power failure for more than 10 minutes (the display shows
basic settings), the process will not recover and the bread baker must be turned on again.
This is possible only when the program was not interrupted later than during the kneading
phase. Then, you can continue by setting your own program (delete already finished
working cycles). However, if the dough was in the last rising phase and the power failure
lasts for longer time, the dough may not be used again and restart with new ingredients is
required.
- Please note that for safety reasons the bread maker does not have upper heating and
therefore, upper bread crust is not as dark as from the bottom and all sides.
Control panel lock
The control panel may be protected against unintentional manipulation with the CYKLUS
(CYCLE) button followed by the BARVA (COLOUR) button. A „key“ symbol will appear
on the display and three beeps will be heard. With the control panel locked, all buttons are
disabled except for the buttons CYKLUS (CYCLE) and BARVA (COLOUR). Unlock the
control panel using the same procedure.
V. PREPARATION FOR USE AND PROGRESS OF BAKING
Unpack the bread baker and accessories. Remove all adhesive foils, stickers or paper
from the appliance. Before first use, wash the parts in contact with foods in hot water with
a detergent, rinse properly with fresh water and wipe or let it dry. Put all dried parts back
to the bread baker and let the lid open. Then, set the program 11-PEČENÍ (BAKING)
and turn it on for 10 minutes without ingredients inserted and then let the appliance cold.
Potential short and mild smoking is not a defect and a reason for complaint.
Place the bread baker on a flat and dry surface (e.g. a table) at height min 85 cm, out of
reach of children. Plug the power cord A5 to an electric socket. Hold the pan B with both
hands, slide it to the appliance and push to lock it in the centre of the baking space A2.
We recommend greasing the shafts and blades with suitable heat-resistant fat/margarine
for easier removal of the blades from the bread. Then, insert two kneading blades C on
the shafts in the baking pan. Slide the blades on the shafts with the flat area down and
either towards or apart each other in the baking pan. Use the spoon and cup D, E to insert
ingredients in order specified in your recipe.
57
GB
/ 210