MBM Corporation 352S - Manual (Page 32)

Operator's Manual multipli 35 Air Feeder PBA 35
Mathias Bäuerle GmbH 35
Setting the Sheet
Gap The sheet gap can be changed by means
of a set screw (1).
This adjustment changes the speed of
the suction drum, i.e. the gap between
sheets is the result of the speed differen-
ce between feed drum and fold rollers.
1
!
Make the setting only with the machine turned off!
• Small gap between sheets:
Turn the set screw (1) all the way clockwise by means of a 2-mm Allen key.
For all parallel folds with the exception of letter fold in fold plate 1 and 2.
• Large gap between sheets:
Turn the set screw (1) all the way counter-clockwise by means of a 2-mm Allen
key. To be used when the sheet length in the first fold plate is larger than half
the length of the unfolded sheet (example: letter fold in fold plate 1 and 2).
The feed speed has no influence on the speed of the fold rollers.
Folding speed is set separately.
On machines equipped with a batch counter, the sheet gap is set at the batch
counter (see paragraph "Counters, Sheet gap in feeder").
If no sheet gap is desired (high speed stream feeding), i.e. when the operating
mode "Without sheet gap control" is chosen at the batch counter, the sheet
gap can be optimized by means of the set screw (1).
Positioning the
Paper Stack • Fan the paper stack to avoid
double sheets.
• Place the stack on the feed table
(2).
• Position the rear paper stop (3).
It prevents the paper from sliding
off towards the rear.
3 2