MBM Corporation 352S - Manual (Page 45)

Operator's Manual multipli 35 Operation and Trial Folds
Mathias Bäuerle GmbH 49
15. OPERATION AND TRIAL FOLDS
After all adjustments have been completed for a
particular job, check the result by making a few
trial folds. Make minor corrections using the fine
adjustment knobs on the fold plates.
!
Exercise caution in the vicinity of rotating
shafts and rollers! Hair, loose garments
and jewellery may get caught!
SERIOUS INJURY MAY RESULT!
!
Do not get close to rotating shafts and rollers while the machine is
running and the noise-absorbing cover is open!
SERIOUS INJURY MAY RESULT!
!
Exercise caution in the vicinity of the
perforating- and slitting knives! They
have sharp edges for proper function!
SERIOUS INJURY MAY RESULT!
multipli 35 F
(Friction Feeder)
MATHIAS BÄUERLE
MATHIAS BÄUERLE multipli 35
Place the properly fanned paper stack on the feed table.
Set the folding speed to medium speed.
If the machine is equipped with two fold units, the
second fold unit must be set to a slower speed than
the first fold unit.
Start the machine - switch position "I".
Machines with two fold units are equipped with a central
On/Off switch. When both fold units are set to "I", the
two fold units can be simultaneously switched on or off
using this switch.
Make some trial folds.
Stop the machine - switch position "0".
It is good practice to interrupt the sheet feed before
switching off the machine. This is done by pushing
down the stack in the feeder with your hand to prevent
sheets from being fed. Then turn the switch to "0".
Remove the trial folds and check the fold.
If the machine is equipped with a total counter, the count must be
set to "0" by pressing the C key after the set-up of the machine has
been completed.