Orion System VCM-X/RNE Controller - Manual (Page 2)

SD CARD UPDATING INSTRUCTIONS
The Modular Service Tool and Modular System Manager are equipped with
an SD memory card. This SD card can be removed and easily updated
through a computer by downloading updates, as they become available,
from our website to your computer.
In order to perform any updates, your computer needs an SD card drive or
you will need to purchase an SD card adapter.
Download instructions are found in Appendix B on page 81 of this manual.
WattMaster Controls, Inc.
8500 NW River Park Drive · Parkville , MO 64152
Toll Free Phone: 866-918-1100
PH: (816) 505-1100 · FAX: (816) 505-1101
E-mail: [email protected]
Visit our website at www.orioncontrols.com AAON ® is a registered trademark of AAON, Inc., Tulsa, OK.
WattMaster Controls, Inc. assumes no responsibility for errors
or omissions.
This document is subject to change without notice.
Form: OR-VCMXRNEOISD-TGD-01G
Copyright April 2015 WattMaster Controls, Inc.
www.orioncontrols.com
IMPORTANT NOTICE
This technical guide provides instructions for using the Modular Service
Tool SD and Modular System Manager SD with the VCM-X, VCM-X E-BUS,
RNE & VAV/Zone Controllers only. If you are using a different controller,
you can download the applicable SD Technical Guide listed below from our
website—orioncontrols.com. The technical guides can also be printed from
the SD card.
SA E-BUS Controller - AA-SAOISD-TGD
VCB-X Controller - OR-VCBXOISD-TGD
VCM Controller - OR-VCMOISD-TGD
VAV/CAV and MUA II Controllers - OR-VAVCAVMUAOISD-TGD