Pacific Research Solutions RI-200 User Manual
Page 11
Pacific Research Solutions
RI-200 User Manual
Page 10
Review the following procedure to enter this “Hello” ID into the controller. Un-key your radio after each command, you
should hear a CW “OK”. This will tell you that you did everything correctly. If you hear a CW “ERROR”, a mistake was
made and the command was aborted.
S-Command
Description
1.
123456
Unlock the controller, you are in S-Command mode. You should notice a different courtesy tone.
2.
63 085
S-Command 63, set the memory data pointer (start line number pointer) to start line 085.
3.
31 001
S-Command 31, Enter message data into memory, Start Of Message.
4.
31 023
S-Command 31, Enter message data into memory, Set tone generator to 697 Hz.
5.
31 042
S-Command 31, Enter message data into memory, Set CW speed to 16 WPM.
6.
31 088
S-Command 31, Enter message data into memory, CW Space.
7.
31 069
S-Command 31, Enter message data into memory, CW “H”.
8.
31 066
S-Command 31, Enter message data into memory, CW “E”.
9.
31 073
S-Command 31, Enter message data into memory, CW “L.
10.
31 073
S-Command 31, Enter message data into memory, CW “L.
11.
31 076
S-Command 31, Enter message data into memory, CW “O”.
12.
31 002
S-Command 31, Enter message data into memory, End Of Message.
13.
64
S-Command 64, Terminate the end of this memory segment.
14.
68 085
S-Command 68, Trigger a message or macro at start line 085. Use this to test your message.
15.
69
S-Command 69, Lock the controller, you are done.
Now you are ready to enter your ID message. Use the above example to organize your message. There are blank table forms
in the appendix that can be used to keep track of the data. It is important to know how the memory is organized so that you
will know what the next available start line will be. The table below shows the default ID and how the above data was stored
into memory.
MESSAGE TABLE
Line #
D1
D2
D3
D4
D5
D6
D7
D8 NOTE
085
3
1
0
2
3
0
4
2
Default ID “HELLO”
086
0
8
8
0
6
9
0
6
087
6
0
7
3
0
7
3
0
088
7
6
C
D
1.
The first two digits “31” are the start of message marker. This data is automatically entered into memory as a result of
the S-Command “31 001”.
2.
Each of the next groups of three digits represents each of the CW commands.
3.
The first of the CW commands “023” is the tone frequency.
4.
The next CW command “042” is the CW speed.
5.
After the CW speed are each of the characters you wish to use.
6.
The last two data items are the end of message “C” and end of segment “D” commands. These two digits are the result
of S-Commands “31 002” and “64”.
Because the ID is the last item stored in the data memory, you do not need to worry about damaging other data in the
memory. You should still keep track of the memory used by your ID so that you will know what the next available start line
is.
Rather than using Morse code in some of your messages, you can use tones of various pitch or lengths with pauses in any of
your messages. See CW commands 101 through 166.