Pacific Research Solutions RI-200 User Manual
Page 54
Pacific Research Solutions
RI-200 User Manual
Page 53
4.5.87
EDIT TELEPHONE NUMBER ACCEPT TABLE
The telephone number accept table is used to control which telephone numbers are allowed for dialing. If the reject table is
turned off, only numbers in the accept table will be allowed for dialing. If the reject table is turned on and the controller does
not find a match in the accept table, the controller will look for a match in the reject table. If the controller finds a match in
the accept table, the controller will only look in the reject table positions 50 through 99 for a reject match. We call this an
exception and can be used to reject specific numbers in a group of accepted numbers. You could reject all toll calls and
accept one or two toll call area codes but reject a group of numbers in those area codes, like 976 numbers. Valid digits are 0
through 9, *, # and A for one second pause. “*” is used as wild cards digit and a “*” at the end of the string acts as a wild
card for multiple digits. You should include a “*” at the end of all entries to limit extra digits from being used. See section
6, telephone interconnect, of additional information on use of the accept and reject tables.
SYNTAX:
87 [Accept position] [Telephone number]
MINIMUM:
Accept position 00, Telephone number 0 digits (clears accept number)
MAXIMUM:
Accept position 99, Telephone number 16 digits
UNITS:
See above
DEFAULT:
Nothing stored.
EXAMPLE:
87 00 15306729053*
Accept Pacific Research Solutions number for dialing, position 00
87 01 1213*
Accept all number in the 213 area code for dialing, position 01
4.5.88
TELEPHONE NUMBER REJECT TABLE ENABLE
This command will turn on / off the reject number table. If the accept table is on and the reject table is off, only numbers that
match the accept table will be available for dialing. See section 6, telephone interconnect, of additional information on use of
the accept and reject tables.
SYNTAX:
88 [on/off]
MINIMUM:
0
MAXIMUM:
1
UNITS:
0 = Off and 1 = On
DEFAULT:
0
EXAMPLE:
88 1
Turn on the reject table.