Pacific Research Solutions RI-200 User Manual
Page 48
Pacific Research Solutions
RI-200 User Manual
Page 47
4.5.65
RESERVED FOR FUTURE COMMAND
4.5.66
RESERVED FOR FUTURE COMMAND
4.5.67
RESERVED FOR FUTURE COMMAND
4.5.68
MACRO LINE JUMP
This command can be used at the end of a macro to jump to another macro start line number. You can also use this
command to test or execute a macro when you are in the S-Command mode. Be careful not to create a loop where at the end
of one macro you jump to another and at the end of the second macro you jump back to the first.
SYNTAX:
68 [Macro start line]
MINIMUM:
1
MAXIMUM:
999
UNITS:
1 – 999 Macro start line
DEFAULT:
N/A
EXAMPLE:
68 34
Jump to macro starting at line 34 and continue executing S-Commands
4.5.69
EXIT S-COMMAND PROGRAMMING
When you are finished making changes to S-Commands, use this command to lock the controller and exit the S-Command
mode. If no S-Commands are executed for 5 minutes, a timer will automatically lock the controller for you.
SYNTAX:
69
DEFAULT:
N/A
EXAMPLE:
69
Exit S-Command Programming mode
4.5.70
TELEPHONE OUTGOING CALL MODE
This command is used to setup how the controller operates when making outgoing telephone calls. Outgoing calls operate
under the rules determine by modes 0 through 4. In mode 2, and if you are operating full duplex, you can listen to the caller
while you are talking on the repeater. In mode 3, other people on the repeater will not be able to hear you talk to the caller.
Mode 4 is the same as mode 3 except a tone is added to repeater TX when you talk to the caller.
SYNTAX:
70 [Mode]
MINIMUM:
0
MAXIMUM:
4
UNITS:
Mode 0 = Disable outgoing call mode, no telephone call can be made.
Mode 1 = Simplex auto patch, telephone audio is muted when the repeater receiver is active.
Mode 2 = Duplex auto patch, telephone audio and repeater audio are mixed at the transmitter.
Mode 3 = Mute receiver audio, telephone and repeater audio are muted when the receiver is active.
Mode 4 = Repeat cover tone, a cover is added to the repeater audio when the receiver is active.
DEFAULT:
1, Simplex
EXAMPLE:
70 2
Set the telephone outgoing mode to duplex.