Pacific Research Solutions RI-200 User Manual
Page 44
Pacific Research Solutions
RI-200 User Manual
Page 43
4.5.56
PASSWORD FOR TELEPHONE INCOMING RING ACCESS
The telephone ring PASSWORD is used to start the ringing process on the repeater for incoming calls, also see
S-Command 71, incoming call mode. This password is only used in S-Command 71 modes 3 and 4. The controller will
answer the telephone company ringing and provide an answer massage to the caller. After this message, the ring password is
used to start the ring process on the repeater to let someone listening to the radio know that a caller is waiting on the
telephone. The factory default password is 343 and can be changed to another password, from 1 to 6 digits long. “C” is the
only digit that cannot be used in this password. Avoid using “A”, “B” and “D” as these digits are not typically available on
standard telephones. For more information, see section 6 of this manual, telephone interconnect.
SYNTAX:
56 [Telephone ring password]
MINIMUM:
1 digit
MAXIMUM:
6 digits
UNITS:
DTMF digits 0 through 9, * and #
DEFAULT:
343
EXAMPLE:
56 5419
The ring password is now 5419
4.5.57
PASSWORD FOR TELEPHONE INCOMING CONTROL ACCESS
The telephone incoming control PASSWORD is used to access the User Command mode of the controller during an
incoming telephone call. This password can only be used in S-Command 71 modes 2 through 4. The factory default
password is 654381 and can be changed to password from 1 to 6 digits long. “C” is the only digit that can not be used in this
password. Avoid using “A”, “B” and “D” as these digits are not typically available on standard telephones. When selecting a
password, you should avoid using one that is similar to a user command or the exact equivalent to an S-Command and its
data. For more information, see section 6 of this manual, telephone interconnect.
SYNTAX:
57 [Telephone control password]
MINIMUM:
1 digit
MAXIMUM:
6 digits
UNITS:
DTMF digits 0 through 9, * and #
DEFAULT:
654381
EXAMPLE:
57 3355
The control password is now 3355
4.5.58
REMOTE SOFTWARE RESET
This command allows for a method to reset the controller remotely, same as a power on reset. You can also execute this
command through a link (another attached RI-200 controller) or from the telephone. The serial number of your controller is
required to operate this command. You can find the serial number of the controller located on the controller. Please make a
note of the serial number and keep it in a safe place.
SYNTAX:
58 [Serial number]
MINIMUM:
N/A
MAXIMUM:
N/A
UNITS:
Serial number is 8 digits long.
DEFAULT:
Your RI-200 Serial number
EXAMPLE:
58 87654321
Resets the controller software only. This example will not be your serial number.