Pacific Research Solutions RI-200 User Manual
Page 51
Pacific Research Solutions
RI-200 User Manual
Page 50
4.5.77
TELEPHONE OFF-HOOK TIME-OUT TIMER
This command will limit the maximum duration of a telephone call. Once the telephone goes off-hook, this timer will start.
Upon reaching the time-out the repeater user will hear a warning message and 30 seconds later the telephone will
automatically go on-hook. During the 30 second warning message, you can re-send the off-hook user command to reset this
timer.
SYNTAX:
77 [Time]
MINIMUM:
0 (no time-out)
MAXIMUM:
240
UNITS:
Minutes
DEFAULT:
10 Minutes
EXAMPLE:
77 30
Set off-hook time-out for 30 minutes
4.5.78
TELEPHONE INACTIVITY ON RECEIVER TIME-OUT TIMER
During a telephone call and each time the repeater input changes state, COS on or off, this timer will be reset. If a
time-out occurs before the input of the repeater changes state, the telephone will go on-hook. This timer is useful if someone
operates out of range of the repeater or a transmitter locks up the repeater input.
SYNTAX:
78 [Time]
MINIMUM:
0 (no time-out)
MAXIMUM:
240
UNITS:
Seconds
DEFAULT:
60 Seconds
EXAMPLE:
78 120
Set inactivity on receiver time-out for 120 seconds.
4.5.79
TELEPHONE INCOMING AGC AUDIO LEVEL
An AGC (Automatic Gain Control) is used in the audio from the telephone to the repeater transmitter. This command is used
to set the initial AGC audio level from the telephone. The AGC will operate in a smaller range of this course setting. If the
telephone audio is typically too low or too high, you can adjust the overall range of the AGC with this command. A larger
value equals a higher level setting. You can turn off the AGC by setting the AGC to zero.
SYNTAX:
79 [Level]
MINIMUM:
0 (Disable AGC)
MAXIMUM:
7
UNITS:
Levels 1 through 7
DEFAULT:
4
EXAMPLE:
79 6
Set telephone AGC level to 6
4.5.80
FLASH HOOK SWITCH
The RI-200 will function with a telephone line that has call hold or call waiting. This command is used to do a flash hook for
1/2 of a second. You can build a user command with a macro to call this S-Command for access to call waiting.
SYNTAX:
80
DEFAULT:
N/A
EXAMPLE:
80
Telephone flash hook