Pacific Research Solutions RI-200 User Manual
Page 50
Pacific Research Solutions
RI-200 User Manual
Page 49
4.5.73
TELEPHONE INCOMING CALL CONTROL TIME-OUT
This time-out is used to hang up the telephone in the incoming call control mode if no DTMF activity is detected. Each time
a control command is received over the telephone, the timer is reset.
SYNTAX:
73 [Time]
MINIMUM:
0
MAXIMUM:
14
UNITS:
Minutes
DEFAULT:
3 Minutes
EXAMPLE:
73 2
Set incoming call time out to 2 minutes.
4.5.74
TELEPHONE INCOMING CALL RING AND COMMAND PASSWORD TIME-OUT
This time-out is used to hang up the telephone if no ring password or control password is detected within the preset time.
This command is used with incoming call S-Command 71 modes 2 through 4.
SYNTAX:
74 [Time]
MINIMUM:
1
MAXIMUM:
120
UNITS:
Seconds
DEFAULT:
30 Seconds
EXAMPLE:
74 90
90 Seconds will be allowed for a ring or control password to be received.
4.5.75
TELEPHONE INCOMING RING DELAY
The controller will count the incoming rings before it will begin any ringing on the repeater or go off-hook for control. Once
the total incoming rings have expired and depending on the incoming call mode (S-Command 71), the controller will begin
its incoming call procedure.
SYNTAX:
75 [Ring]
MINIMUM:
0
MAXIMUM:
15
UNITS:
Ring count
DEFAULT:
4 Rings
EXAMPLE:
75 2
Set ring delay counter for 2 rings.
4.5.76
TELEPHONE TX RING LIMIT
This counter limits the total number of ring messages that are allowed to be transmitted over the repeater. Be careful when
using the no limit mode, in S-Command 71 modes 2 – 4 the repeater will not stop ringing over the air.
SYNTAX:
76 [Ring]
MINIMUM:
0 (No limit)
MAXIMUM:
31
UNITS:
Ring limit
DEFAULT:
8 Rings
EXAMPLE:
76 15
Set maximum rings on the repeater to 15.