Pacific Research Solutions RI-200 User Manual
Page 28
Pacific Research Solutions
RI-200 User Manual
Page 27
4.5.08
COURTESY MESSAGE TIMER
The courtesy message timer is the selected time from COS carrier dropping, to the start of a courtesy message. This applies
to ALL types of courtesy messages. If the carrier is picked up prior to the courtesy timing out, the courtesy message will be
skipped. When the courtesy message is started, the repeater time out timer is also reset.
SYNTAX:
08 [Time]
MINIMUM:
0 (Disable Courtesy)
MAXIMUM:
99 (9.9 Seconds)
UNITS:
Tenths of seconds (1/10 Seconds or 100 ms)
DEFAULT:
20 (2.0 Seconds)
EXAMPLE:
08 35
3.5 Seconds
4.5.09
LED STATUS DISPLAY ON/OFF
The LED status display serves no purpose when someone is not present at the repeater. This command can be used to turn
the LED status display on or off to reduce controller current drain. In low power or solar powered systems, this function can
be useful to reduce the controller total power consumption.
SYNTAX:
09 [Mode]
MINIMUM:
0 (Off)
MAXIMUM:
1 (On)
UNITS:
Mode 1 = On, Mode 0 = Off
DEFAULT:
Mode 1, On
EXAMPLE:
09 0
Turns Status LED display off (reduce system current drain)
4.5.10
REPEATER TIMEOUT TIMER
The time-out timer sets the maximum length of a single transmission for a user. When the user’s transmission time has been
exceeded, the repeater transmitter PTT is turned off, un-keyed. The COS must drop and the courtesy message started for this
timer to reset. Before and after a timeout, the repeater will send a message to notify the user/s. These messages are called pre
and post time-out messages.
The use of a “*” in the time field will manually reset the timer if a user talks too long or if continuous noise on the repeater
input has timed out the repeater. The timer can be reset by capturing the signal on the repeater input and by issuing the time-
out reset S-Command. The reset command will need to be terminated with a “C” under the above condition. This command
could be sent over the Auxiliary Link or telephone if needed.
SYNTAX:
10 [Time]
MINIMUM:
* (Manual reset), 0 (Disable time-out)
MAXIMUM:
255
UNITS:
Tenths of minutes or 6 second increments.
“*” = Manual reset time out timer.
DEFAULT:
30 (3.0 Minutes)
EXAMPLE:
10 10
The user will time out the repeater in 1.0 minute.
4.5.11
RESERVED FOR FUTURE COMMAND