Seaward 350 PrimeTest - Manual (Page 21)

PrimeTest 350 Operating Instructions
- 20 -
5 Getting Started
5.1 Charging New Batteries
Before using the PrimeTest 350 for the first time the
rechargeable cells provided will need to be inserted
into the unit and then charged. See section 17.4.
5.2 Power On
Switch on the PrimeTest 350 by pressing, and holding,
the green ON/START key. After 2-3 seconds the unit
will beep and the display will show a ‘boot up screen’.
This screen will show the firmware version installed.
The first time the PrimeTest 350 is powered up the
User will be automatically set to Admin. The Admin
user gives full access to all the menus and functionality
of the unit.
For further information about changing User and
Password see section 10.3 – Change User & section
10.4 – Change Password.
The PrimeTest 350 will now be ready to use in Manual
mode. Refer to section 11 for more details.
5.3 How to Navigate Menus
Most of the functions within the PrimeTest 350 can be
accessed from the menus.
Press Menu (F4) to select the main menu. Use the
up/down arrow keys to highlight the desired function or
sub-menu. Press either OK (F4) or the right arrow key
to select.
Note: An alternative method of navigating the
menus is to use the Fast Key option. Press
Menu (F4) and note that each menu option
has a letter underlined. By pressing that
letter key the menu option will be selected.
The right arrow can also be used to select a
menu option.