Seaward 350 PrimeTest - Manual (Page 35)

PrimeTest 350 Operating Instructions
- 34 -
9.1.3 Delete Sequence
Sequences can be deleted if no longer required to
make space for new sequences. A further prompt is
presented to avoid accidental deletion.
Note: If a sequence is accidentally deleted the
factory Sequences can be restored by
following the steps in section 9.5
9.1.4 Creating a New Sequence
A new test sequence can be created using either
“Insert New Sequence” or “Add New Sequence”.
“Insert” will insert a blank test sequence at the currently
highlighted position in the list. “Add” will add a blank
test sequence onto the end of the lists.
The default name for a new sequence is “Test
Sequence n” where n is the next available location.
There are 17 factory sequences and so the first time
New Sequence is used the default name is “New
Sequence 18”.
To build the new sequence, use the arrow keys to
highlight the sequence name and press Edit (F4) to
open the sequence editor as shown below.
Pressing Edit (F4) allows the sequence name to be
changed.
To insert a test into the sequence, press Insert (F1) to
open the Insert a Test window and use the left or right