H3C Technologies H3C S10500 Series Switches - Manual (Page 110)

102
Figure 60 Removing the chassis (S10508) from the rack
(1) Loosen the captive screws that attach the mounting brackets to the rack
(2) Slide the chassis outwards along the slide rails
5. Put the chassis onto the pallet base of the wooden carton.
Removing the air filter
1. Prepare the packing bag of the air filter. Make sure the bag is clean, dry, and not damaged.
2. Remove the air filter from the side of the chassis.
For how to remove an air filter, see "
Replacement procedures ."
3. Put the air filter into the bag.
Removing cable management brackets and mounting brackets
Before repackaging the switch chassis, remove the cable management brackets and mounting brackets
from the chassis.
Removing the mounting brackets
1. Prepare the packing box of the mounting brackets. Make sure the box is clean, dry, and not
damaged.
2. As shown in Figure 61 , use a Phillips screwdriver to loosen the screws that attach the mounting
brackets to the chassis, and then remove the mounting brackets.