H3C Technologies H3C S10500 Series Switches - Manual (Page 32)

24
Installing a power module
An AC power module and a DC power module are installed in the same way. This section uses an AC
power module as an example. For information about AC and DC power modules, see H3C AC2500
Power Module User Manual and H3C DC2400 Power Module User Manual.
Some power module slots do not have a blank panel. The figures in this section are for illustration only.
To install the power module:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see "
Attaching an ESD wrist strap ."
2. Use a Phillips screwdriver to loosen the captive screws on the blank filler panel (if any) to remove
the blank filler panel.
3. Unpack the power module.
4. Follow the installation graph printed on the blank filler panel of the power module to install the
power module in a correct direction:
a. Grasp the handle of the module with one hand and support the module bottom with the other.
b. Push the power module along the guide rails into the slot until it has firm contact with the slot.
For vertical slot installation, see callout 1 on
Figure 21 . For horizontal slot installation, see
callout 1 on Figure 22 .
5. Press the handle inward until the handle seats into the slot.
6. As shown in callout 2 on Figure 21 , use a Phillips screwdriver to fasten the captive screw on the
handle to attach the power module.