H3C Technologies H3C SR8800 - Manual (Page 122)

112
Figure 76 Affixing a label
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure the
label is facing out, as shown in Figure 77 .
Figure 77 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For more
information, see " Affixing a label to a signal cable ." For the example of affixed labels, see Figure 75 .
TO:
B03 – 48V2