H3C Technologies H3C SR8800 - Manual (Page 76)

66
• Emulation—VT100
Power supply system failure
Table 27 AC power module LED description
LED Color Status Description
Input Green
Steady on Power is being correctly input.
Off The power module is absent or has input voltage error.
Output Green
Steady on The power module is correctly outputting power.
Off The power module has output voltage error or is absent.
Fault Red
Steady on
The power module is experiencing an overvoltage, overcurrent, or
over-temperature condition.
Off The power module is operating correctly or absent.
Table 28 DC power module LED description
LED Color Status Description
IN (input) Green
Steady on Power is being correctly input.
Off The power module is absent or has input voltage error.
OUT (output) Green
Steady on The power module is correctly outputting power.
Off The power module has output voltage error or is absent.
FAIL (fault) Red
Steady on
The power module is experiencing an overvoltage, overcurrent, or
over-temperature condition.
Off The power module is operating correctly or absent.
When the input/output LEDs are off or the fault LEDs are on, the power module does not operate
correctly.
To troubleshoot the power supply system:
1. Examine the power cord connections. If a power cord is loose, re-plug the power cord.
2. Replace the power cord, and verify that the LEDs are normal.
3. Examine the power module installation. If the power module is not fully seated, re-install the power
module to make sure it makes close contact with the backplane of the router.
4. Examine the power source. Make sure the power source is operating correctly and provides a
normal voltage.
5. Verify that the power module has not encountered output short circuit, output over-current, output
over-voltage, input under-voltage, or over-temperature problems.
6. Power off the router, plug the power module into an empty power module slot, and verify that the
power module can operate correctly. If the power module can operate correctly, the power
module slot might have failed. Otherwise, proceed with the next step.
7. Plug a new power module of the same model into the same power module slot, and connect it to
the same power source. If the new power module can operate correctly, the old power module
fails. Contact the agents to replace the old power module.