Installing mounting brackets, Installing air filters (optional), Figure 9 – H3C Technologies H3C SecPath M9000 Series User Manual
Page 20
12
Figure 9 Attaching cable management brackets to an M9006 gateway
(1) Place the cable management bracket against the installation position on the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for attaching the cable management bracket to the chassis
(4) Power cable management bracket
Installing mounting brackets
Before installing the gateway to the rack, install the mounting brackets to the chassis. Marks L and R are
printed inside the mounting brackets to distinguish between the left and right mounting brackets. To
install the mounting brackets, face the front of the gateway, and attach the left and right mounting
brackets to the two sides of the gateway, as shown in
.
Figure 10 Installing the mounting brackets to an M9006 gateway
(1) Screws for attaching the mounting brackets to the chassis
(2) Mounting brackets
(3) Signal cable management brackets
Installing air filters (optional)
Air filters are installed at the air inlet vents to prevent dust from entering the chassis. If you have ordered
air filters, install the air filters before mounting the gateway to the rack.