Installing a cfp module – H3C Technologies H3C SecPath M9000 Series User Manual
Page 28
20
{
For an SFP+ module, press the module down against the upward force of the bottom spring tab
so you can push the module straight into the port.
{
If you cannot hold the module by its two sides because of high module density, press the module
on its head end to push it in.
Figure 20 Installing an XFP/SFP+/SFP/QSFP+ transceiver module
Installing a CFP module
CAUTION:
•
Read the following instructions before installing a CFP module. Failure to follow these instructions might
cause damage to the CFP module.
•
Do not remove the dust plug from the CFP module before connecting an optical fiber.
•
Before installing a CFP module, remove the optical fiber, if any, from it.
To install a CFP module:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded. For
more information, see "
."
2.
Unpack the CFP module. Do not touch the golden finger of the module.
3.
Gently push the CFP module into the slot until it has firm contact with the slot, and then fasten the
captive screws on the CFP module.