H3C Technologies H3C SecPath M9000 Series User Manual
Page 9
1
Preparing for installation
The H3C SecPath M9000 Multi Service Security Gateway Series includes these models:
•
M9006
•
M9010
•
M9014
Safety
To avoid bodily injury and equipment damage, read all safety recommendations carefully before
installation. Note that the recommendations do not cover every possible hazardous condition.
General safety guidelines
•
Keep the gateway clean and dust-free.
•
Do not place the gateway on a moist area, and avoid liquid flowing into the gateway.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
•
Keep the gateway and installation tools away from walk areas.
•
Do not wear loose clothing, jewelry (for example, necklace) or any other things that could get
caught in the chassis when you install and maintain the gateway.
Electricity safety
•
Clear the work area of possible electricity hazards, such as ungrounded power extension cables,
missing safety grounds, and wet floors.
•
Locate the emergency power-off switch in the room before installation so you can quickly shut power
off when an electrical accident occurs.
•
Unplug all external cables, including power cords, before moving the chassis.
•
Do not work alone when the gateway has power.
•
Never assume that power has been disconnected from a circuit. Always check.
Handling safety
CAUTION:
Do not hold the handle of the fan tray, power module, or back cover of the chassis, or the air vents of
chassis to move the gateway. Any attempt to move the gateway with these parts might cause equipment
damage and even bodily injury.
When you move the gateway, follow these guidelines:
•
Remove all external cables, including the power cords, before moving the chassis.