Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 212)

26 October 2009 K2 Storage Area Network Installation and Service Manual 212
Configuring server A - Part 1
in the following table:
On this page… Do this…
Define server roles
If the K2 SAN has one or
more optional NH servers,
then FTP traffic should go to
the NH server, not the K2
Media Server you are now
configuring. In this case, do
not select the FTP server role
or the NAS server role.
Enter the name for the K2 Media Server, as currently configured on the
machine.
Enter the name or IP address of the Ethernet switch, as currently
configured on the switch, to which the K2 Media Server is connected.
For Level 20R redundant, select all roles, except if NH server is present
do not select FTP server or NAS server.
Click
Next
Software Configuration
This page checks for the
software required to support
the roles you selected on the
previous page.
If software with Yes in the Required column reports as Not Installed, you
must first install it on the before continuing. After installing the software,
click
Check Software . When all required software reports as Installed,
click Next .