iSys V12 Thermal Printer - Manual (Page 14)

14
3.4 MEDIA INSTALLATION
Installing rolled paper
The V12 plotter is shipped with a sample roll of thermal sensitive paper. To install rolled
paper:
1. Release the lid assembly by grasping underneath the black latch bar and pulling it upwards
(Figure 7-1). Open the plotter lid by lifting it straight upwards.
2. Remove the fan-fold guide by grasping the two stainless steel rails and lifting it straight
upwards.
3. Place the spindle hubs onto each end of the roll of media with the 11.65 spacer on the left
hand side spindle.
4. Orient the roll so that the paper feeds off of the top of the roll.
5. Place the roll in the plotter so that the pins on the spindle hubs snap into the slots on the
spindle blocks.
6. Guide the paper over the blue platen roller and under the black cutter bar as shown in Figure
3-3.
7. Figure 3-4 shows roll paper installed. When installing any media, ensure that the coated side
of the media is on top. V12 Rev 2.0.2000