iSys V12 Thermal Printer - Manual (Page 17)

17
Figure 3-8 Fan-fold paper installed
Installing and using film
To install rolled film:
1. Release the lid assembly by grasping underneath the black latch bar and pulling it upwards
(Figure 7-1). Open the plotter lid by lifting it straight upwards.
2. Remove the fan-fold guide by grasping the two stainless steel rails and lifting it straight
upwards.
3. Place the spindle hubs onto each end of the roll of media with the 11.65” spacer on the left
hand side spindle.
4. Orient the roll so that the film feeds off of the top of the roll.
5. Place the roll in the plotter so that the pins on the spindle hubs snap into the slots on the
spindle blocks.
6. Guide the film over the blue platen roller and under the black cutter bar shown in Figure 3-3.
7. Figure 3-4 shows rolled media installed. When installing any media, ensure that the coated
side of the media is on top.
NOTE: The cutter bar does not cut film. Use a knife or scissors.
Installing the fan-fold feeder tray
Install the optional fan-fold feeder tray by sliding the bracket holes over the bolts on the back of
the plotter.