iSys V12 Thermal Printer - Manual (Page 38)

38
Replacing the fuse
The fuse is located in a clip within the AC receptacle. See Figure 7-27.
1. Unplug the power cable from the AC receptacle.
2. Insert a small screwdriver into the slot on the fuse clip to release the fuse holder.
3. Remove the fuse from the holder. Replace with new fuse and reinsert the fuse holder into the
receptacle.
WARNING: Replace only with a fuse of identical specifications, other fuses may cause a fire
hazard. Refer to Chapter 2 Specifications, for fuse specifications.
WARNING: Consistent damage to or blowing of the fuse indicates an electrical problem, and a
severe shock hazard may exist. Call an Imaging Systems Group customer service
representative for assistance.