Extron Electronics Matrix 200 - Manual (Page 11)

Extron • Matrix 200 • User’s Manual
Chapter 1 • Introduction to the Matrix 200
1-3
Optional Features
• Front Panel Controller (FPC)
• SmartControl

microprocessor
• QuickSwitch™ Front Panel Controller (QS-FPC)
• Redundant power supply
Front Panel Controller (FPC)
The Front Panel Controller (FPC) provides local control of all Matrix 200 Switcher
functions. It is supplied as an optional accessory to the Matrix 200 and is
intended for users who wish to supplement normal RS-232/RS-422 computer
control with local or remote operator control. For even greater flexibility, two
FPCs can be connected to the same Matrix 200 - one mounted to the front of the
Matrix 200 and the other located remotely. Refer to Chapter 2 for instructions on
mounting the FPC, and to Chapter 4 for FPC operation. The FPC includes the
following features:
Control Microprocessor “SmartControl TM ” is the Front Panel’s built-in microprocessor. It determines the
Matrix 200 input/output configuration, what presets are saved, as well as all other
switcher settings. SmartControl effectively configures the Matrix 200.
Trouble Status Indication The SmartControl microprocessor continuously monitors Matrix status, and also
alerts the user to any problems that may have occurred, such as: loss of power
(if the Matrix 200 has the optional redundant power supply) or loss of front panel
control when using the optional FPC. This helps isolate any equipment
malfunction quickly.
Configuration Memory SmartControl can store up to 20 different connection configurations (called
presets). This can save hours of reprogramming each I/O configuration. The
Front Panel Controller (FPC) allows for easy configuration of inputs and outputs,
as well as the control of additional system features.
Two separate FPCs can be used to control one Matrix 200 switcher. For
example, a second FPC could be used to control the switcher from as far away
as 200 feet. When controlling the switcher via RS-232/RS-422, the FPC may or
may not be needed.
LCD Menu-driven The Front Panel includes a lighted, liquid crystal display (LCD) that is used to
SmartControl step through the setup and program functions necessary to install and operate
the Matrix 200. A full complement of function buttons makes setup and
programming of the unit fast and easy.