Extron Electronics Matrix 200 - Manual (Page 17)

Extron • Matrix 200 • User’s Manual
Chapter 2 • Hardware Installation
This chapter covers only the installation of the Matrix 200 hardware. Connecting
its inputs and outputs is covered in Chapter 3 and setup is covered in Chapter 4.
IEC Power Panel
The IEC Power Panel consists of an On/Off switch, a fuse cover and two male
power connectors. The second connector is provided for a redundant power
supply.
Standard Power Supply
The Matrix 200 Series switcher/router has an auto-switching power supply that
operates from any input voltage from 90 to 260 VAC, 50/60 Hz. No equipment
changes are necessary.
Fuse
Fuse Type = 5mm x 20mm
Fuse Rating = 250V, 0.8A Super Slo Blo
Power Switch
Power Switch - 1 = On
0 = Off
Redundant Power Supply (optional)
To improve equipment reliability in critical applications, the Matrix 200 can be
configured with a redundant internal power supply. With this option, the
Matrix 200 will automatically switch to the backup supply if the primary supply
fails. If the Matrix 200 switches to the backup power supply, it continues to
operate without interruption and sends a command to the Host system to
indicate a change in status. If the Matrix has a Front Panel Controller or
QuickSwitch Front Panel Controller, the Power LED will flash to alert the user
that a power failure has occurred.
_______ To install this optional power supply, see procedure on page 2-9.
Front Panel Controller
The Front Panel Controller (FPC) provides local control of all Matrix 200
functions. This optional feature is intended to supplement normal RS-232/
RS-422 computer control with a local or remote operator control. As described in
the following pages, the FPC can either be mounted on the front of the
Matrix 200 or installed remotely, up to 200 feet, by means of an RJ45 cable
connected to the rear panel.
Two FPCs can be connected to the same Matrix 200 - one on the front and the
other located remotely and connected to the rear panel of the Matrix 200. Refer
to the following pages for instructions for mounting and connecting the FPC to
the Matrix 200.
_______ The following pages include procedures for panel installation.
QuickSwitch Front Panel Controller
The QuickSwitch Front Panel Controller (QS-FPC) provides local control of all
Matrix 200 functions. This optional feature is intended to supplement normal
RS-232 computer control with a local or remote operator control.
REDUNDANT POWER FUSE: 250V ~0.8A TT AC POWER INPUT
100-240V ~0.5A MAX 50/60 Hz
!
DISCONNECT ALL POWER CORDS BEFORE SERVICING
2-1