Extron Electronics Matrix 200 - Manual (Page 73)

Extron • Matrix 200 • User’s Manual
Appendix A • Part Numbers, Glossary and Troubleshooting
Related Part Numbers
Switcher Module Part Numbers
Extron Part Part #
Blank Front Panel .................................. 60-147-01
Front Panel Controller (FPC) ................. 60-146-01
QuickSwitch Front Panel Controller ....... 60-188-01
Audio Connectors (Phoenix) .................. 10-163-01
SVHS-to-BNC Adapter ........................... 26-353-01
GLI 350 .................................................. 60-223-02
- (Ground Loop Isolator, 250 MHz RGBHV)
PA 250 ................................................... 60-179-01
- (Peaking Amplifier, 200 MHz RGBS)
Matrix 200 User’s Manual ...................... 68-126-01 - (this manual)
SC 110 Sync Combiner (115v) .............. 60-153-01 (230v = 60-153-02)
SC 210 Sync Processor (115v) ............. 60-154-01 (230v = 60-154-02)
Option Kit Part Numbers
Kits can be ordered from Extron for adding modules to an existing Matrix 200.
The following list gives part numbers for available kits.
Matrix 200 Option Kit Part #
Redundant Power Supply ...................... 70-020-01
8 x 8 Stereo Audio Module .................... 70-022-01
4 x 4 HRAM (for RGB) ........................... 70-023-01
8 x 4 HRAM (for RGB) ........................... 70-023-02
8 x 8 HRAM (for RGB) ........................... 70-023-03
4 x 4 Sync Module ................................. 70-058-01
8 x 4 Sync Module ................................. 70-058-02
8 x 8 Sync Module ................................. 70-058-03
4 x 4 Composite Video ........................... 70-025-01
8 x 4 Composite Video ........................... 70-025-02
8 x 8 Composite Video ........................... 70-025-03
These kits include all the necessary parts, as well as instructions for a qualified
person to add options to a Matrix 200. Chapter 2 of this manual includes some
procedures for adding options.
When ordering an upgrade kit, it is necessary to know the revision level of the
Matrix being modified.
• The Main Controller has two labels on the bottom of the cabinet. One is the serial
number and the other is the “ER” number. To be ready for audio, for example,
the number must be ER7670 or greater.
• If the serial number has an “A” after it, that also means the unit can accept
Audio.
• If the Matrix has a Front Panel Controller (FPC), its firmware must be version 1.3
or greater. (There is no connection between the FPC version number and the
one for the Main Controller board.)
If your Matrix 200 is not at the required level, the appropriate upgrade kit(s) will
be shipped with the option kit.
A-1