Extron Electronics Matrix 200 - Manual (Page 54)

Extron • Matrix 200 • User’s Manual
Chapter 4 • Using the Front Panel Controller
Create a Timing Sequence (menu 5)
1. To create a timing sequence, place the cursor at the upper left corner of
the LCD display (position 0,0), then use the Up/Down keys to select the
Edit (ED) Submenu, shown here. Observe that the first step of the
sequence (01) is displayed at the far right end of the top row.
2. Move the cursor to position 1,5 and enter the preset number (1-20) to be used
in this step of the sequence. (Only saved presets may be used.)
3. Move the cursor to the appropriate time digits (shown as hh:mm:ss) and enter
the time duration for this sequence step. (Use the 24-hour clock.) Numbers
can be entered directly from the keypad or by scrolling with the Up/Down
keys.
_______ The maximum time duration is 16:59:59.
4. Move the cursor to the top, right position (0,15) and change the number (Up
key) for the next step in the sequence. Repeat 2 and 3 to set the preset
number (1-20) and the time duration for the next step of this sequence.
Repeat this for each step in the sequence.
5. Repeat 2 thru 4, above, until all steps of the sequence have been set.
6. When finished, press Enter to store the sequence.
Edit a Timing Sequence (menu 5)
To edit a sequence, place the cursor at position 0,7 and enter the number of the
sequence to be edited. Repeat steps 2 - 6 (above) to make changes until the
sequence is correct.
To delete a step (for example, delete step 03) from a sequence, load the
sequence and scroll to the step to be deleted (03). Press Delete (the # key). The
steps that followed step 03 will move forward. Step 04 now becomes Step 03,
etc.
To insert a new step in a sequence, display the SQ:ED menu, shown above.
For this example, we will insert a new step before step 4, of sequence 2. The
new step will use preset 6 for a duration of 12 minutes.
1. Choose the number of the sequence to be altered (02).
2. Use the cursor keys to display the number of the step where the new step will
be inserted (04).
3. Press Insert (the * key).
4. Move the cursor to position 1,4/5 and enter the preset number to be used (06).
5. Move the cursor to the minutes position (mm) and enter the time (12).
6. When finished, press Enter to store the new step.
4-12