Extron Electronics Matrix 200 - Manual (Page 57)

Extron • Matrix 200 • User’s Manual
Chapter 4 • Using the Front Panel Controller
Program Start Time/Date (menu 6)
The Program menu to the left has 7 selection points. Use the Left/Right cursor
keys to step from one to another. Three selection points are indicated by the
character ">". These are used to define the type of Program menu. The other
four selection points are for entering data.
1. To program a sequence (or a preset) start date/time, place the cursor at
position 0,2 (PG>)and use the Up/Down keys to select the Start Day menu
shown here.
2. Press the Right cursor key to step the cursor to the 0,9 position. Use the Up/
Down cursor keys to select which is to be programmed: SEQ (Sequence) or
PRE (Preset).
3. Press the Right key again to step to position 0,13 and use the Up/Down keys
to select the desired Preset (or Sequence) number. (Where picture shows
01.)
4. Step the cursor to position 1,2, and use the Up/Down keys to select “DAY”.
5. Use the Left/Right buttons to move the cursor through the positions to be
changed (1,8 - 1,15). Use the numeric keypad to enter the numbers for the
day (dy), month (mo), and year (yr) for the desired start date. For example, 31
October, 1997 should become 31/10/97.
6. Repeat the above steps 3 and 4. This time select the “TIME” menu, and enter
the start time at positions 1,8 - 1,15. Use the keypad keys to enter hour (hh),
minute (mm), and second (ss) for the desired start time. For example, 3:15
p.m. is 15:15:00.
_______ When entering a 2-digit number from the keypad, it is not necessary to move the
cursor for each digit. The SmartControl enters the first number in the left position
and the second number to the right. For example, to enter 15 minutes, put the
cursor at “mm” and press “1”, and then “5”.
7. Press Enter to store the program.
Program Delete (menu 6)
There can be only one program in the Matrix 200 at one time. To delete the
program, move the cursor at position 0,2 in the Program Menu and use the Up/
Down keys to display the Delete Menu. See illustration at left.
Press Enter to delete the program.
4-15