Extron Electronics Matrix 200 - Manual (Page 39)

Extron • Matrix 200 • User’s Manual
Chapter 3 • Rear Panel Connections
S-Video Input Connections
S-Video (S-VHS) is typically the output from the AV source on a 4-pin miniature
din-type connector and must be converted to 2 BNC type connectors - one for
Chroma (C) and the other for Luminance (Y).
_______ For S-VHS to BNC interface, use Extron cable 26-353-01.
To connect S-Video to the Matrix 200, the Matrix must be ordered with two
composite video modules. Use one for Luminance (Y) and the other for Chroma
(C). The Y and C signal lines are then connected to the two video modules. See
illustration on facing page.
_______ When connecting Y and C cables, be sure to use the same input numbers on the
two video modules for each source. This example uses number 1 inputs. Also,
use the same output number pair for each destination. This example uses
number 1 outputs, but we could have used outputs number 2, or 3, etc.
Input Connections
Choose which input number to use to connect the S-Video source device to the
Matrix 200. Connect the Luminance (Y) to the input connector on the first (left)
Video module and the Chroma (C) to the same input number on the second
(right) Video module.
If audio is used, connect the right and left audio source outputs to the right and
left inputs on the back of the Matrix. See page 3-9 for details on audio
connections.
Output Connections
Choose which Matrix 200 output number to use for the S-Video destination unit.
Connect the Luminance (Y) output from the first (left) Video module to the
Luminance input of the destination unit. Connect the Chroma (C) from the same
output number on the second (right) Video module to the Chroma input of the
Video destination unit.
If audio is used, connect the right and left audio output from the Matrix connector
to the right and left inputs of the audio destination unit. See page 3-9 for details
on audio connections.
_______ A Matrix 200 can be configured with RGsB (sync on green) and S-Video.
3-7