Extron Electronics Matrix 200 - Manual (Page 61)

Extron • Matrix 200 • User’s Manual
Chapter 4 • Using the Front Panel Controller
Host Baud Rate Submenu (menu 9)
This submenu displays the baud rate of the host controller: 9600 baud. This is a
fixed value and cannot be reset.
Show Clock Time & Date (menu 9)
With the cursor at position 0,0, use the Up/Down cursor keys to display “CLK:”
on the top row of the display. This submenu is used to display the date and time
of the internal clock. This is a view-only submenu; no user input is required.
Read clock date and time, as shown here.
Set Clock Time & Date (menu 9)
1. With the cursor at position 0,0 and the Clock Submenu displayed, use the Up/
Down cursor keys to display “SET”, as shown here.
2. Using the Left/Right cursor keys, position the cursor under the day (da) pair of
digits on the top row. Use either the Up/Down cursor keys or the keypad keys
to set the current day.
3. Using the Left/Right cursor keys to move the cursor and the Up/Down keys (or
keypad keys) to change the numbers, set the current month (mo) and year
(yr).
_______ When entering a 2-digit number from the keypad, it is not necessary to move the
cursor for each digit. The SmartControl enters the first number in the left position
and the second number to the right. For example, to enter 15 minutes, put the
cursor at “mm” and press “1”, and then “5”.
4. Use the same procedure to set the hour (hh), minutes (mm) and seconds (ss).
5. Return the cursor to the 0,0 position. Press the Enter key to save the setting
to memory.
4-19