Extron Electronics Matrix 200 - Manual (Page 51)

Extron • Matrix 200 • User’s Manual
Chapter 4 • Using the Front Panel Controller
1. With the Delay RGB->Sync menu displayed, the cursor should be at 1,0. Use
the Up/Down cursor keys to select All, Out1, Out2, etc., for a specific output.
2. Use the cursor keys to position the cursor at position 1,11. Use the Up/Down
cursor keys to sequence through the available delay times in increments of 1
second (0 thru 9) until the desired delay time is displayed.
(If required, step to position 1,13 and set a value for “tenths” of a second.)
3. Press Enter to store the sync delay value.
4. Press Menu to continue setup, or press Escape to return to the default menu.
Mute Output Menu (3)
This menu allows selective muting of individual outputs from the Matrix 200.
There are three choices for muting selective outputs: RGB, AUD and ALL,
where ALL includes RGB and AUD. If the Matrix does not have audio, that will
not display as a choice.
To select the Mute Menu, press Menu, followed by “3” on the numeric pad.
To change the Mute Output Settings, do the following:
1. With the Mute menu displayed, and the cursor under the >, use the Up/Down
keys to select the function to be changed (RGB, AUD or ALL).
2. Use the Right/Left keys to move the cursor to the output to be muted.
3. Use the Up/Down keys to switch between Y (yes) and N (no).
Repeat steps 2 and 3 until all choices have been made.
4. Press Enter to save the setup.
5. Press Escape to return to default menu.
4-9