Changing the main fuse, Extron • matrix 200 • user’s manual, Conductor cable, up to 100 feet – Extron Electronics Matrix 200 User Manual
Page 22: Conductor cable, up to 200 feet
Extron • Matrix 200 • User’s Manual
Chapter 2 • Hardware Installation
Installing the FPC for Remote Operation
The rear panel of the Matrix 200 has an 8-conductor RJ45 connector used to
plug a cable from a remote FPC. The remote FPC can be used independently, or
as a second FPC, in parallel with one mounted to the front of the Matrix 200. The
use of one or more FPCs does not interfere with normal RS-232/RS-422 control
of the Matrix 200 switcher.
The diagram below shows the cable connection from the remote FPC to the
Matrix 200. The remote panel can be mounted in another rack, or any convenient
location.
Changing the Main Fuse
To change the AC power fuse, you must first unplug the IEC power cable. This
allows access to the fuse holder. Use a small, flat
screwdriver to press into the notch and pull the holder
straight out. There is a storage place for a spare fuse.
Replace the blown fuse* (see picture right) and slide the
fuse holder until it snaps in place.
There is also an AC fuse on each of the two boards that
make up the power supply. Each fuse is located next to
the AC input connector. These fuses are accessible by
removing the top cover of the Matrix.
* Use 250V, 0.8A Super Slo Blo Fuse
AC POWER INPUT
FUSE: 250V ~0.8A TT
2-6
O
O
U
U
TT
P
P
U
U
TT
S
S
O
O
U
U
TT
P
P
U
U
TT
S
S
O
O
U
U
TT
P
P
U
U
TT
S
S
8-conductor
cable, up to
100 feet
LISTED
1T23
ITE
c
8-conductor
cable, up to
200 feet