Extron Electronics Matrix 200 - Manual (Page 28)

Extron • Matrix 200 • User’s Manual
Chapter 2 • Hardware Installation
11. Plug the remaining I/O Ribbon cables from each module to a connector on
the Main Controller board (See below). Since the Main Board connectors
are the same, connect the cables for neatness and convenience. For
example, the illustration below shows the Red I/O module connected to J5,
the Green to J6, etc.
Warning: When working close to the other I/O modules, be careful that you do not change any
other DIP switch settings.
12. Be sure the cables are securely plugged into the Main board, and then drop
the six screws into the six holes in the Audio Module (See below). Wiggle
each screw by hand to align it with the threads below and tighten them with a
screwdriver.
_______ The red stripe on the ribbon cables (pin 1) is to the right, on the Main Controller
and Audio boards. (See the picture below.) It must point up on the other I/O
modules.
13. With all connections and screws secure, route the cables away from the
power supplies. Use tie wraps to tie cables together where they follow the
same path.
14. If no other modifications are required, put the top cover back on the
Matrix 200 and put it back in its working position.
If the Matrix has an FPC, the new Power On message will show “A” in position
6. See example. Other digits depend on the configuration. The new
configuration will also appear in Request ID information sent to the Host
system via the RS-232/RS-422 port.
If other modifications are required, go to the appropriate procedure.
Red
Black
Audio
2-12