Extron Electronics Matrix 200 - Manual (Page 47)

Extron • Matrix 200 • User’s Manual
Chapter 4 • Using the Front Panel Controller
Changing Tie Submenus
Many of the menus have submenus. To change Tie level, use the Left/Right
cursor keys to place the cursor at (0,3) under the >. Use the Up/Down cursor
keys to display the desired level.
The choices that appear will depend on how the Matrix is configured. For
example, if a Matrix has RGBS, Composite Video and Audio, the Tie Menu
choices will be: ALL, RGB, Red, Grn, Blu, Syn, Cv2 and Aud.
The cursor is a blinking line under the position where changes can be
made. The Left/Right cursor movement steps only to those positions
that can be accessed.
Tie All Level
In the Tie All menu, connections to all I/O ports (RGB, VID, and AUD) are made
simultaneously.
1. If not presently in the (default) Tie Menu, press the Escape key. Observe that
the cursor is at the 0,3 position, as in the figure above.
2. If not already displayed, use the Up/Down cursor control keys until the word
“ALL” is displayed to the right of the cursor.
_______ A blinking period (“.”) in any position of the lower row of the LCD display
indicates that this output connection is different on each plane (Breakaway).
3. Use the Left/Right cursor keys to move the cursor under the first input/output
connection to be connected. For example, to connect input 3 to output 1,
place the cursor under the “0” in the bottom row, under output #1 (position
1,8).
4. With the cursor positioned under the input/output position, do either one of the
following:
Use the Up/Down cursor keys to step to “3”,
or
Press the “3” key on the numeric keypad.
Observe that the “3” in the bottom row is blinking to signify a “tentative”
connection, meaning that the connection has not yet been stored in memory.
(See menu at top of page.)
5. Move the cursor under the next input/output connection to be made and enter
the desired input number. Continue doing this until all tentative input/output
connections have been made. Observe that all input/output connections to be
changed are now blinking. (Those that are not to be changed will not blink.)
6. Press Enter to store the input/output connections into memory.
4-5