Extron Electronics MLC 104 Plus Series - Manual (Page 182)

MLC 104 Plus Series • Index C-2
Index
PRELIMINAR
Y
Index
Symbols
0.evt 1-5
.gc2 A-12
.gcz A-12
A
accessories, part numbers for A-8
advanced configuration
options in Global Configurator 3-12
alert notification
using digital input to trigger 5-17
amplifier
using with an MLC and a volume controller 5-25
ASCII to decimal conversion table 4-12
ASCII to hex conversion table 4-4
audio level, limiting on power-up
SIS command for 4-33
audio settings, SIS commands for
limit audio level on power-on 4-33
auxiliary port. See MLS RS-232 (slave switcher) port
See auxilliary switcher
See also RS-232 protocol
auxilliary switcher
configuring 3-14
enable slaving (SIS command for) 4-39
B
button labels
installing or replacing 6-2
button press/release emulation 4-35
buttons
associations with IRCM-DV+ 4-34
button control SIS commands 4-37
button press repeat commands 4-38
default SIS commands for input buttons 2-4
front panel button LED control 4-38
installing or replacing button labels 6-2
moving a button cap 6-3
press/release emulation (SIS commands) 4-35
slave map (button associations for a slaved
switcher) 4-37
types, functions, and operation 2-3
virtual mapping for an IRCM-DV+ 4-34
C
cdc files 3-20
description of file type A-12
CM/IR/SCP (CommLink) port 2-12
wiring and uses 2-12
CommLink
CM/IR/SCP (CommLink) port 2-12
configuration
saving and uploading 3-15
Configuration embedded Web page 3-17
configuration ports
Config (host control) port 2-5, 2-9
connector pin assignments 2-23
Control embedded Web page 3-21
controlling the MLC 3-15
control modules
overview 1-5
copyright message
sent by the MLC 4-2
crossover network cable
connector wiring and when to use 2-19
used for configuration via Telnet 3-6
custom GUI service 3-24
customizing control Web pages 3-24
customizing HTML files 5-33
cut-out templates A-13
MLC 104 IP Plus AAP or MLC 104 IP Plus DV+ A-14
MLC 104 IP Plus L A-15
MLC 104 Plus and MLC 104 IP Plus A-13
MLM 104 6GWP A-17
MLM 104 LAAP A-16
D
defaults
IP addresses 4-2
LAN port 2-19, 4-2
delay times, SIS commands for 4-33
device drivers
serial
viewing in embedded Web page 3-22
digital I/O ports
digital input, about 2-14
digital inputs, using 5-15
digital output, about 2-16
digital outputs, using 5-20
location on unit 2-10
wiring, purpose, voltages 2-14
DIP switches
MLA-VC10 5-26
display (projector) power
advanced settings in Global Configurator 3-12
display control 1-3
Display control (Display RS-232/IR) port wiring 2-10
distance
IR learning distance from remote to MLC 2-8, 2-20
maximum distance to an SCP, IR repeater, or control
module 2-12
to display or projector 2-11, 5-29
E
e-mail
sending by pressing a button (special application) 5-11
eir file type A-12