Emerson MICRO MOTION 1700 - Manual (Page 15)

2 Mounting and sensor wiring for
integral installations
Topics covered in this chapter:
• Mounting and sensor wiring
• Rotate the transmitter on the sensor (optional)
• Rotate the user interface on the transmitter (optional)
• Ground the flowmeter components
2.1 Mounting and sensor wiring
There are no separate mounting requirements for integral transmitters, and no need to
connect wiring between the transmitter and the sensor.
2.2 Rotate the transmitter on the sensor (optional)
In integral installations, you can rotate the transmitter on the sensor up to 360º in 90º
increments.
Components of an integral transmitter Figure 2-1:
A
B
C
D
A. Cap screws
B. Transmitter
C. Transition ring
D. Sensor
Mounting and sensor wiring for integral installations
Installation Manual 11