Emerson MICRO MOTION 1700 User Manual
Page 29
Display components
Figure 3-9:
A.
Transmitter housing
B.
Sub-bezel
C.
Display module
D.
Display screws
E.
End-cap clamp
F.
Cap screw
G.
Display cover
1.
Shut off power to the unit.
2.
Remove the end-cap clamp by removing the cap screw.
3.
Turn the display cover counterclockwise to remove it from the main enclosure.
4.
Carefully loosen (and remove if necessary) the semicaptive display screws while
holding the display module in place.
5.
Carefully pull the display module out of the main enclosure until the sub-bezel pin
terminals are disengaged from the display module.
Note
If the display pins come out of the board stack with the display module, remove the pins and
reinstall them.
6.
Rotate the display module to the desired position.
7.
Insert the sub-bezel pin terminals into the display module pin holes to secure the
display in its new position.
8.
If you have removed the display screws, line them up with the matching holes on the
sub-bezel, then reinsert and tighten them.
9.
Place the display cover onto the main enclosure.
Mounting and sensor wiring for 4-wire remote installations
Installation Manual
25