Emerson MICRO MOTION 1700 - Manual (Page 16)

1. Loosen each of the four cap screws (4 mm) that fasten the transmitter to the base.
2. Rotate the transmitter counter-clockwise so that the cap screws are in the unlocked
position.
3. Gently lift the transmitter straight up, disengaging it from the cap screws.
Important
Do not disconnect or damage the wires that connect the transmitter to the core processor.
4. Rotate the transmitter to the desired orientation.
Important
Do not pinch or stress the wires.
The slots on the transition ring should be aligned with the cap screws.
5. Gently lower the transmitter onto the base, inserting the cap screws into the slots.
6. Rotate the transmitter clockwise so that the cap screws are in the locked position.
7. Tighten the cap screws, torquing to 20 to 30 in-lbs (2.3 to 3.4 N-m).
2.3 Rotate the user interface on the transmitter
(optional)
The user interface on the transmitter electronics module can be rotated 90º or 180° from
the original position.
Mounting and sensor wiring for integral installations
12 Micro Motion ® Model 1700 and 2700