Roland SPD-SX Sampling Pad with 4GB Internal Memory (Black) - Manual (Page 30)

Sampling
30
5.
Use the cursor buttons and the [-] [+] buttons to make settings for sampling .
Parameter Value Explanation
REC LEVEL 0–100
Adjusts the volume at which sampling will occur.
Produce sound on the device that’s connected to the SPD-SX, and adjust the volume until it’s
as high as you can get it without causing the level overload indication to appear.
Level overload indication Level meter
AUTO START OFF, 1–15
When you press the [F2] (START) button, sampling will begin the moment that the input
signal exceeds the level you specified here.
If this is “OFF,” sampling will begin the moment you press the [F2] (START) button.
KIT001–100, PAD1–9
Specifies the kit and pad to which the sampled wave will be assigned.
* You can only select an empty pad, one which has no wave assigned to it.
Signal flow
AUDIO IN jacks
REC LEVEL
[GAIN] knob
Analog signal Digital signal
Level meter
Adjust to avoid the level
overload indication
Adjust appropriately for
the connected device
COMPUTER connector
Start sampling
6.
Press the [F1] (STBY) button .
The sampling standby screen will appear.
7.
Start sampling .
If you set AUTO START “OFF” in step 5
Sampling will begin when you press the [F2] (START) button. Produce sound on the device that’s connected to the SPD-SX.
While sampling is taking place, the screen will indicate “NOW SAMPLING...”
If you set AUTO START to anything other than “OFF” in step 5
Produce sound on the device that’s connected to the SPD-SX; sampling will begin when the input signal exceeds the level
specified by AUTO START.
While sampling is occurring, the screen will indicate “NOW SAMPLING...”