Sony BRAVIA XR A95K 55" 4K HDR Smart QD-OLED TV User Manual
Page 8
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to
operate this equipment.
All interface cables used to connect the equipment to peripherals must be shielded type to comply with EMC standard(s)
and to prevent undesired operation due to radiated emissions. When cables are supplied, always use them for this
purpose.
If you have any questions about this product, you may call:
Sony Customer Information Service Center 1-800-222-7669 or
US Requirements for Risk Group 3 (RG3) Laser Illuminated Projectors
US owners of RG3 laser projectors must obtain a permit (called a ‘variance’) at time of purchase to possess and use
this product. Sony or the Sony distributor will assist purchaser in procuring the variance. Contact a Sony sales
representative for additional data.
The requirement for a variance also applies to RG3 laser projector dealers, distributors and resellers.
US laser product regulations require specific mounting and accessibility considerations during installation and use.
See included data.
Operators of RG3 laser projectors shall be legal employees of the variance holder.
Certain requirements for training, record keeping and reporting apply. Refer to Sony RG3 laser projector user training
materials.
Users must review the use terms specified on the variance and follow these conditions at all times under US federal
regulations. These regulations are administered by the US Food and Drug Administration’s Center for Devices and
Radiological Health (F.D.A. CDRH). Failure to follow the terms of use specified in the variance can result in fines and
revocation of permit to use RG3 projectors.
RG3 laser projectors may only be transferred, sold or rented to other personnel or entities in the US if they possess
an RG3 projector or laser light show variance.
When installed by a certified installer in accordance with the installation instructions, this product can be used in
private screening room.
Precautions
On safety
Check that the operating voltage of your unit is identical with the voltage of your local power supply.
Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by qualified personnel
before operating it further.
Unplug the unit from the wall outlet if it is not to be used for several days.
To disconnect the cord, pull it out by the plug. Never pull the cord itself.
The wall outlet should be near the unit and easily accessible.
The unit is not disconnected to the AC power source (mains) as long as it is connected to the wall outlet, even if the
unit itself has been turned off.
Do not look into the lens while in use.
Do not place your hand or objects near the ventilation holes. The air coming out is hot.
Removing or changing the lens shall only be performed by qualified Sony personnel
On preventing internal heat build-up
After you turn off the power with the /
(On/Standby) button, do not disconnect the unit from the wall outlet while the
cooling fan is still running.
8