Sekonic Speedmaster L-858D-U Light Meter - Manual (Page 18)

4
2. Before Use
2-2 Inserting the Batteries
1.
Prepare two AA batteries.
2.
Unlock the Battery Cover Latch e , and remove the Battery Cover d .
3.
Insert the batteries according to the "+" and "–" symbols in the
Battery Compartment j .
4.
Align the tabs (three locations) of the Battery Cover d to the holes
of the meter. While pressing down the Battery Cover d , use the
Battery Cover Latch e to lock the Battery Cover d .
Tabs (Three)
Battery Cover Latch
e
Battery Cover
d
Battery Compartment
j
WARNING
Do not place batteries in open flames, attempt to short, disassemble, apply
heat to, or recharge them (except rechargeable batteries). They may burst and
cause fires, serious injury, or damage to the environment.
CAUTION
● Use the manganese or alkaline batteries.
● Do not use batteries with any other rating than the one specified. Also, do
not mix old and new batteries.
● To prevent corrosion of battery contact pieces or deterioration of the
waterproof feature, exercise care to ensure that the rubber packing of the
Battery Cover
d
is not contaminated with dust or sand.
● Please insert the batteries minus "-" side first.
When removing the batteries, remove them plus "+" side first.
● lf the meter will not be used for an extended period of time, it is recommended
to remove the batteries to avoid possible damage caused by battery leaking.