Sekonic Speedmaster L-858D-U Light Meter - Manual (Page 93)

79
5. Measuring
5-2-2 Cordless Multi (Cumulative) Flash Mode
This Measuring Mode is used when the light generated by the flash at one time is
inadequate for the desired F-stop setting. Repeated flash pops can be accumulated
until the desired F-stop value is displayed.
When the Measuring Button
6
is pressed, the light meter is set to the Standby
Mode (90 seconds) and makes a measurement by activating the flash. The
measured value (F-stop) is displayed for each trigger of the flash.
The cumulative count is infinite. Up to 99 times is displayed in the Status/Title field,
however, the cumulative count returns to 0(zero) for more than 100 times (0=100,
1=101, 2=102, etc.).
1) Measuring
Operation
1.
Touch the Measuring Mode Icon on the Measuring Screen.
The Measuring Mode Screen is displayed.
2.
Touch the icon ( ) on the Measuring Mode Screen.
When it is selected, the display changes to the Measuring Screen.
Measuring Screen Measuring Screen
[Measuring
Mode] Icon
Measuring Mode Screen
3.
Set the light receiving method.
Switch to the Incident light, extended lumisphere ( )/retracted lumisphere ( ), or
reflected light. (  P32 , P37)