HP E1418A - Manual (Page 143)

Channel Current
Offset Calibration
Registers
The Channel Current Offset Calibration Registers store current offset
calibration constants in non-volatile memory. There are 16 registers, one
for each output channel. The register at base + 140
16
stores channel 1,
base + 142
16
stores channel 2, up to base 15E
16
to store channel 16.
This register is non-volatile.
Address
Base + 140
16
through
Base + 15E
16
Bit 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
msb lsb
WRITE Unused Current Offset Calibration Constant
Current Offset Calibration Constant: Writing a 16-bit value to this field
sets a new constant used to calibrate the channel output. Values are in the
range:
000
16
maximum positive offset
800
16
nominal (zero) offset
FFF
16
maximum negative offset
Notes Registers 00100
16
through 001BE
16
are located in non-volatile (FLASH)
memory. Writing to this memory requires a complicated sequence of
register accesses not documented here. It is recommended that calibration
be performed using the SCPI driver for the module, not register access.
Non-volatile memory has finite life, based upon the number of writes.
Use care when writing to this memory.
The contents of this register are loaded into volatile memory at power-on
and not used on an on-going basis.
142 HP E1418A Register-Based Programming Appendix B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com