HP E1418A - Manual (Page 83)

OUTPut:TTLTrg n [:STATe]?
OUTPut:TTLTrg n [:STATe]? queries if the specified VXIbus TTLTRG line is set to
be a source of trigger from the module.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
TTLTrg n keyword 0 to 7 none
Returns: unsigned 16-bit integer (uint16).
Comments •
This query returns a 1 if the specified VXIbus TTLTRG line is enabled as a
trigger source. This query returns a 0 if the specified VXIbus TTLTRG line is
disabled as a trigger source.
•
Related Commands: OUTPut:TTLT n [:STATe]
OUTPut n [:STATe]
OUTPut n [:STATe] < state > opens or closes the specified channel output relay.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
OUTPut n keyword 1 to 8 or 1 to 16 none
< state > boolean OFF | ON | 0 | 1 none
Comments •
In the keyword, OUTPut n, the valid range of n is:
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
•
This command sets the output state of individual channel output relays. Use the
DIAGnostic:OUTPut:ALL[:STATe] command to set all channels with a single
command.
•
*RST Condition: All output relays open.
•
Related Commands: OUTPut n [:STATe]? , DIAGnostic:OUTPut:ALL[:STATe]
OUTPut
82 HP E1418A SCPI Command Reference Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com