HP E1418A - Manual (Page 67)

CALibration
The CALibration commands are used during periodic calibration of the module.
Calibration is described in Appendix D of this manual, beginning on page 154. You
should review Appendix D before using any of these commands.
Subsystem Syntax CALibration
:CONDition?
:CONFigure
:RESistance?
:RESet
:STORe
:TEST?
:VALue
:RESistance < value >
CALibration n
:CONFigure
:CURRent?
:VOLTage?
:VALue
:CURRent? < value >
:VOLTage? < value >
CALibration
66 HP E1418A SCPI Command Reference Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com