Honeywell 9782 Series - Manual (Page 143)

Microprocessor Board Switch Settings
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual Appendix C - 1
Appendix C
Microprocessor Board Switch Settings
Introduction
The information in this appendix will not be needed for normal set up and operation of the 9782
Analyzer/Controller. It is included here for use during troubleshooting with the telephone
assistance of the Honeywell Technical Assistance Center.
Location of switches
Two 8-position DIP switches are mounted on the microprocessor board (far left board). The
switch locations are shown in Figure C-1.
9
8
7
6
5
4
3
2
1
1
2
3
4
5
6
Switch 1
Switch 2
Figure C-1 Microprocessor Board DIP Switches
Note that S1 switch (030480), CR1-CR8 and CR12-CR16 (188056) are not used as of June 1993.
SW1 - all positions set to off
Regardless of the options used, all eight switches in SW1 are set to off.
SW2 - settings are dependent on options
The settings of the eight switches in SW2 depend on the options used. The appropriate settings
are shown in Table C-1.