Honeywell 9782 Series - Manual (Page 79)

I/O Setup and System Configuration
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 5-23
5.10 Summary of Menu Choices and System Defaults
Introduction
Table 5-10 contains the menu choices available (or ranges for numeric values) and system
defaults for I/O assignments and configuration parameters, as well as for values entered during
maintenance functions described in Section 10, and the TDS conversion factor entered using the
calibration menu described in Section 8. Not every choice shown in this table applies to every
application.
Table 5-10 Menu Choices and System Defaults
PARAMETER CHOICES or RANGE
(Default is underlined)
I/O setup: measurement type 9782C-S0
COND/TDS [total dissolved solids]
RESISTIVITY
9782C-W0
COND/TDS
CONCENTRATION
I/O setup: solution temperature compensation type 9782C-S0
NaCl
NH3/ACID/ETA
MORPHOLINE
NaCl (TDS)
NH3 (TDS)
MORPHOLINE(TDS)
9782C-W0
NaCl
HCl
NaOH
H2SO4
NaCl(TDS)
HCl(TDS)
NaOH)TDS)
H2SO4(TDS)
I/O setup: cell constant for Cell 1 0.01
0.1
1.0
10.0
5.0
25.0
50.0
I/O setup: cell constant for Cell 2 0.01
0.1
1.0
10.0
5.0
25.0
50.0
N/A
I/O setup: AutoClean enabled NO
YES
I/O setup: range status enabled NO
YES