Installation procedure, Install hardware, Final hardware installation for dvadb – Hughes Direcway DW6000 User Manual
Page 164
Appendix E • Installing DVADB
130
1033295-0001 Revision 2
Installation procedure
To install DVADB, do the following:
• Install the hardware
• Configure the software
• Test to ensure DVADB is functioning
Before beginning the installation, check the telephone line dialout
sequence. If it does not match the sequence in the installation
specification, or as shown in the Advanced pages, (see
Troubleshooting DVADB on page 134), contact installer support.
Install hardware
1. Attach the RJ-11 cable from the DW6002 Gateway telco port
to a phone splitter (such as the one built into a surge
protector). Then connect the splitter to the existing phone
line. The final configuration will look like Figure 123.
Figure 123: Final hardware installation for DVADB
Telephone
cable
Transmit
cable
AC power
cord
Ethernet
cable
E
th
ernet
Receive
cable
Power
supply
DC power
cord